Due to the fact the coating is so easy to apply and requires normally only one layer to give the full recovery of color and gloss, the product is ideal to replace the existing treatment with a wax coating. For these coatings it is common to sand down the surface several times, followed by 1, 2 or even 3 layers of the wax. With Carecoat Recoseal 10 it is only needed to sand down a heavily eroded (or chalked) surface with a fine grid sand paper (1500 – 3000) to remove deposits stuck in the top layer. After that just a good cleaning/degreasing and the product can be applied by wiping the application pads lightly over the surface. Alternatively the product can also be sprayed onto the surface but please note that the spray is highly flammable!
Since Carecoat Recoseal 10 does not leave white stains on rubber or dark surfaces, there is no need to tape of other surfaces before applying. All these aspects combined make that you can save up to 70% in application time to get your surface bright and shiny again.

Carecoat Recoseal 10 consists of modified organic and inorganic
micro molecules, giving it the following enhanced properties:

• Low viscosity & highly crosslinked
• Curing at high humidity (≤ 90%) and at low temperature (≥ 5° C)
• Long pot life (>6-10 hours)
• Extreme penetration with optimal adhesion
• Outstanding corrosion-, UV-, salt and chemical resistance
• Exceptional gloss retention and excellent abrasion resistance
• Low adhesion of atmospheric pollution; once applied, easy to clean
• Easy and quick in manual application
• Transparent (not pigmented), does not leave white stains